2104/06/19 — Thursday — Begin Antenna Switch Installation

Today, Mike sprayed solar panel field with Roundup so it will be ready to install the frames, which are scheduled to arrive later this month.  It is my understanding that there will be a layer of gravel under the panels to keep grass from interfering with servicing the system.

Mike sprays the solar panel field to prepare it for installation of the solar panel frames.

Mike sprays the solar panel field to prepare it for installation of the solar panel frames.

Jim, Joel, Paul and I began to arrange the antenna switches into their final positions.

Here the antenna switches are on the pad, but are not in their final positions yet.

Here the antenna switches are on their pad, but are not in their correct positions.

Joel, Paul, Jim and Larry (taking photo) are moving the antenna switches into their final positions before connecting them.

Joel, Paul, Jim and Larry (taking photo) are moving the antenna switches into their final positions before connecting them.

Virginia went shopping with Kathy in the big shopping centers in northern Guam.

Our Apartment

A photo tour of our apartment:

Virginia is standing by the door of our apartment.  We are in the far right of three apartments on the second floor.  The other two apartments on our floor are vacant at the moment.  All three apartments on the first floor are occupied.  Joel and Joanna have the middle one.

Virginia is standing by the door of our apartment. We are in the far right of three apartments on the second floor. The other two apartments on our floor are vacant at the moment. All three apartments on the first floor are occupied — we suspect, because they might be a little cooler without the sun beating on the concrete roof. Joel and Joanna have the middle one.

 

Looking into the living room from the kitchen.  The front door is on the extreme right.  The living room has a couch and TV, which is connected to cable.  The cable connection provides our internet service.  We use the internet a whole lot more than the TV.  Occasionally, we will watch CNN news, the only cable news available, but Guam ('where America's day begins') is 14 hours ahead of EDT.  When it is day here, it is night on the mainland.

Looking into the living room from the kitchen — note Virginia’s fresh bread on the stove. The front door is on the extreme right. The living room has a couch and TV, which is connected to cable. The cable connection provides our internet service. We use the internet a whole lot more than the TV! Occasionally, we will watch CNN news, the only cable news available, but Guam (‘where America’s day begins’) is 14 hours ahead of EDT. When it is day here, it is night on the mainland, which means prime-time news is on about 7am — we get Monday evening news on Tuesday morning our time.

The kitchen is rather small.  The back door leads to a small balcony, where a washer, dryer and hot water heater are located.

The kitchen is rather small. The back door leads to a small balcony, where a washer, dryer and hot water heater are located.

Our bedroom has an air conditioner and ceiling fan and just enough room for a bed and dresser.  No blankets or bedspread are needed, or wanted!

Our bedroom has an air conditioner and ceiling fan and just enough room for a bed and dresser. No blankets or bedspread are needed, or wanted!

The second bedroom has been converted into a spare room.  The bed is leaning against the wall.  The bedrooms are the only rooms with air conditioners.  Virginia spends a lot of time reading in here and this is where most of our work on our laptops is done -- including this blog.

We converted the second bedroom into a spare room. The bed is leaning against the wall. The bedrooms are the only rooms with air conditioners. Virginia spends a lot of time reading in here and this is where most of our work on our laptops is done — including this blog and Skype calls.

Of course, no accommodation would be functional without a bathroom.  This one is tiny, but functional.

Of course, no accommodation would be complete without a bathroom. This one is tiny, but functional.

2012/06/18 — Wednesday

We woke up this morning at 3 am because we were getting hot and discovered that the  electricity was off — no air conditioning or ceiling fan!  We went back to sleep on top of the sheets only to wake up at 4:30am feeling cold (relatively speaking).  Thankfully, the electricity was back on!

This is the automation equipment for sending the audio to the three transmitters.  There are two more identical racks to the left for two additional transmitters.  Text has been added to indicate the location of the 'patch panel' which can be used to electrically reroute equipment should the need arise, such as equipment failure.

This is the automation equipment for sending the audio to three transmitters. There are two more identical racks to the left for two additional transmitters. Text has been added to indicate the location of the ‘patch panel’ which can be used to electrically reroute equipment should the need arise, such as equipment failure.

Today, i worked with Joel trying to sort out some wiring issues.  A problem came up as a result of the wires that had been removed yesterday.  While trying to trace the problem, we discovered the audio patch panel has some unexplainable cross connections.  The audio to the various transmitters was ending up at the correct places but was taking a confusing route through the patch panel.  This made tracing the problem extremely difficult.  While correcting the problem, we decided to reconnect the wiring in the patch panel so that all the wiring now followed a logical path.  Hopefully, next time it should take a lot less time to troubleshoot audio problems.

Close up of the patch panel which allows lots of flexibility in 'patching' around equipment problems.

Close up of the patch panel which allows lots of flexibility in ‘patching’ around equipment problems.

This is the wiring on the back side of the automation system and patch panel.  It took quite a bit of tracing wires, but Joel and I finally sorted them out.

This is the wiring on the back side of the automation system and patch panel. It took quite a bit of tracing wires, but Joel and I finally sorted them out.

2014/06/17 — Tuesday — Solar Field Layout

TWR Guam plans to install a large solar panel array to help reduce electricity costs for their station.  Electricity costs on Guam are well over double those typical on the U.S. mainland.  This makes solar panels even more cost effective than in the U.S.

This morning after devotions, I helped Mike lay out the location for the solar panel array that will be arriving later this month.  A smart phone with a compass app was used to obtain the south facing orientation.

Later someone else, as a double check, used their smart phone, which seemed to indicate that the orientation was not correct.  This resulted in considerable discussion of which phone was correct.

I decided to use the website, Google Maps, to determine the north-south axis and discovered that there was a telecommunications tower almost due north.  By comparing the  coordinates (latitude and longitude) of the tower to the coordinates of one side of the solar panel array, it was determined that the communication tower was only 2.5 degrees east of true north.

The north reference is the shorter telecommunications tower in the far background.

The north reference is the ‘shorter’ telecommunications tower in the far background.

I then found another reference point that was only 2 degrees west of true south.

The south reference point is the end of the building which is about 1/2 mile away.

The south reference point is the end of this building which is about 1/2 mile away.

With this information, we made adjustments to the layout after lunch with confidence that the layout is now within 1/2 degree of the desired orientation.

The proposed placement of a 30-kilowatt solar panel array is layed out in front of the transmitter building.

The proposed placement of a 30-kilowatt solar panel array is laid out in front of the transmitter building.  Future expansion of the solar array can be made to the south and east..

After doing this layout, my pant legs were covered with grass seeds, so I decided to tour the antenna field now.  If I would have waited for another day, I would have to remove these pesky ‘stick tight’ seeds a second time. [Actually, Virginia removed them before I got a chance — she said it took about an hour!]  I was amazed at what I saw both from a technical and aesthetic viewpoint.  The following photos show some of the amazing views (I will save the more technical ones for the engineers in Elkhart!):

Looking south from the north edge of the property.  The transmitter building is to the left.  To the right of the transmitter building is the heavy equipment storage building which also houses the standby generators.  The Cocos Resort Island can be seen offshore.

Looking south from the north edge of the property. The transmitter building is to the left. To the right of the transmitter building is the heavy equipment storage building which also houses the standby generators. The Cocos Resort Island can be seen offshore.

Looking north from south of the storage building.

Looking north from the storage building.  The building in the foreground is used for storing antenna parts and rigging.  It was made out of the two 40-foot containers that were used to ship the two Thompson transmitters.  The fuel tank for the standby generators is to the right.

This photo gives the best view of the transmission path to China, India, Indonesia and all of South Asia.  Nothing hinders the signal as it takes off over the Philippine Sea!

This photo gives the best view of the transmission path to China, India, Indonesia and all of South Asia. Nothing hinders the signal as it takes off over the Philippine Sea, especially when you consider that the radiating part of the antenna is over 100 feet above where this photo was taken!

2014/06/16 — Monday — Cleanup

Today was spent cleaning up after removing the two transmitters, that are now in their containers and ready to be transported to the ship.

Some of the smaller sized cables that were removed for 'clean up'.

Some of the smaller sized, now unused, cables that were removed for ‘clean up’.

Copper Ground Straps that were removed and will be saved for future needs.

Copper ground straps that were removed and will be saved for future needs.

The ends of now empty conduits that were sticking up out of the floor were cut off flush with the floor to eliminate tripping hazards.

Trenches that had been filled with conduits and wires were now able to be cleaned of almost 40 years of dirt and rubbish that had collected in the bottom.

Trenches that had been filled with conduits and wires were now able to be cleaned of almost 40 years of dirt and rubbish that had accumulated  in the bottom.